Thermal modelling of cutting tool temperatures and heat partition in orthogonal machining of high-strength alloy steel

Abstract

Cutting temperatures and heat partition into the cutting tool are critical factors that significantly affect tool life and part accuracy during metal removal operations, especially in dry machining. Among many thermal modelling studies, uniform heat partition ratio, and/or uniform heat intensity along the tool-chip interface are frequently assumed. This assumption is not valid in actual machining and can lead to erroneous estimated results in the presence of sticking and sliding friction zones. Therefore, it is necessary to accurately predict the cutting tool temperature and heat partition during machining. This paper presents an analytical thermal modelling approach which considers the combined effect of the primary and the secondary heat sources and determines the temperature rise and non-uniform heat partition ratio along the tool-chip interface. Cutting tests were conducted on AISI/SAE 4140 high-strength alloy steel using carbide cutting tools over a wide range of cutting speeds. Cutting temperatures were measured experimentally using an infrared thermal imaging camera. Experimentally established sticking and sliding friction regions were used to evaluate non-uniform frictional heat intensity along the tool-chip interface. The temperature matching condition along the tool-chip interface leads to the solution of distributed non-uniform heat partition ratio by solving a set of linear equations through programming in MATLAB®. Experimental results show to be consistent well with those obtained from the thermal model, yielding a relative difference of predicted average tool-chip interface temperature from −0.8% to 6.3%. It is found that average heat partition into the cutting tool ( RT) varies from 35% down to 15% for the entire range of cutting speeds. These results suggest that, to address the thermal problem in metal cutting, the research and development of tooling should also focus on reducing friction on the tool rake face in addition to the contribution of the combined effect of primary and secondary heat sources on temperature rise at the tool-chip interface.