Thermal life assessment of laser powder-directed energy deposited NiCrAlY/CuCrZr bimetallic clad for rocket nozzle applications

Abstract

To enhance the thermal life of rocket exhaust nozzles, the hot side of copper liners is coated with thermal barrier coatings (TBCs) to provide thermal insulation and oxidation resistance. However, interface failures often occur between M-CrAlY bond coats and nozzle liners due to significant differences in their thermal expansion coefficients (CTE). This study explores the use of Laser Powder-Directed Energy Deposition (LP-DED) to clad NiCrAlY onto a CuCrZr substrate, as the process offers localized heating which can offer better bond strength. Optimization trials were conducted using single and multi-track studies to identify optimal parameters. Due to the low energy absorption of the CuCrZr substrate to 1070 nm laser sources, cladding was performed at a high energy density of 135 J/mm2 with a 1.2 g/min feed rate to achieve defect-free clads with sufficient diffusion. The bulk of the NiCrAlY clads showed γ′-Ni3Al, β-NiAl, and γ-Ni phases, while Y4Al2O9 and Y2O3 oxides formed on the top surface due to aluminum and yttrium depletion at high temperatures. The clads exhibited cellular dendritic microstructures at the bulk region, and planar microstructures were observed at the dilution zone. EBSD-KAM maps showed higher dislocation density near the interface due to CTE mismatch across substrate and clad. Scratch tests confirmed strong adhesion with no interface cracks, though crack propagation was observed from the edges after 50 isothermal cycles, driven by copper erosion. With Cu diffusion, interface region exhibited a graded microstructure which could enhance CTE, improving compatibility compared to standard NiCrAlY alloys.