Abstract
AbstractA regular Kelvin foam model was used to predict the linear thermal expansion coefficient and bulk modulus of crosslinked, closed‐cell, low‐density polyethylene (LDPE) foams from the polymer and gas properties. The materials used for the experimental measurements were crosslinked, had a uniform cell size, and were nearly isotropic. Young's modulus of biaxially oriented polyethylene was used for modeling the cell faces. The model underestimated the foam linear thermal expansion coefficient because it assumed that the cell faces were flat. However, scanning electron microscopy showed that some cell faces were crumpled as a result of foam processing. The measured bulk modulus, which was considerably smaller than the theoretical value, was used to estimate the linear thermal expansion coefficient of the LDPE foams. © 2004 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 42: 3741–3749, 2004
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: Journal of Polymer Science Part B: Polymer Physics
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.