Abstract
In this study, cellulose nanocrystals (CNC) were synthesized by acid hydrolysis of microcrystalline cellulose (MCC) powder. The morphology of MCC and CNC was examined using energy filtered transmission electron microscopy (EFTEM). Further, poly (lactic acid) (PLA)/CNC nanocomposite was prepared using solution casting technique. The thermal properties (i.e., glass transition temperature, melting temperature, degree of crystallinity, thermal decomposition) of the PLA/CNC nanocomposites were characterized using differential scanning calorimeter (DSC) and thermogravimetry analyzer (TGA). EFTEM studies showed that the CNC exhibited needle-like structure (approximately 10-20nm in width and 250-300nm in length), which is a typical measurements found in wood based nanocellulose. DSC analysis showed that CNC (up to 5wt%) is capable of acting as nucleating agent for PLA. TGA analysis showed that the of decomposition temperatures PLA/CNC nanocomposites were higher than that of pure PLA.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
