Abstract
In this study, the particle size distribution, molecular weight, thermal analysis (TGA) differential scanning calorimetry (DSC) and thermogravimetric analysis, and dynamic mechanical analysis (DMA) of poly(methyl methacrylate) used as dental base material were investigated. The commercial raw material used were prepared for microwave curing, and they were cured by microwave and conventional heat methods. The average particle size of the powder studied (103.1 μm) were much larger than that of the commercial powders (50–78 μm) for conventional curing. The particle size dietribution were almost symmetrical and narrow. The viscosity-average molecular weight were larger for microwave curing and increased with curing time. The glass transition temperature Tg measured (about 110°C) by DSC increased with curing period in microwave oven. The values of Tg were close to each other for both curing techniques. The degradation temperature range observed by TGA were 200–377°C. The movements of molecular chains in their conformations were studied by DMA in the form of changes in different mechanical properties with temperature. It was shown that crosslinking increased with increase of curing time. The changes were more noticeable in microwave curing compared to conventional heat curing. © 1999 John Wiley & Sons, Inc. J Appl Polym Sci 74: 2971–2978, 1999
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a call