Theoretical Study of a Novel Power Cycle for Enhanced Geothermal Systems

Abstract

As obtained geofluids from enhanced geothermal systems usually have lower temperatures and contain chemicals and impurities, a novel power cycle (NPC) with a unit capacity of several hundred kilowatts has been configured and developed in this study, with particular reference to the geofluid temperature (heat source) ranging from 110 °C to 170 °C. Using a suitable CO2-based mixture working fluid, a transcritical power cycle was developed. The novelty of the developed power cycle lies in the fact that an increasing-pressure endothermic process was realized in a few-hundred-meters-long downhole heat exchanger (DHE) by making use of gravitational potential energy, which increases the working fluid’s pressure and temperature at the turbine inlet and, hence, increases the cycle’s power output. The increasing-pressure endothermic process in the DHE has a better match with the temperature change of the heat source (geofluid), as does the exothermic process in the condenser with the temperature change of the sink (cooling water), which reduces the heat transfer irreversibility and improves the cycle efficiency. Power cycle performance has been analyzed in terms of the effects of mass fraction of the mixture working fluids, the working fluid’s flowrate and its DHE inlet pressure, geofluid flowrate, and the length of the DHE. Results show that, for a given geofluid’s temperature and mass flowrate, the cycle’s net power output is a strong function of the working-fluid’s flowrate, as well as of its DHE inlet pressure. Too high or too low of a DHE inlet pressure results in a lower power output. When geofluid temperature is 130 °C, the optimum DHE inlet pressure is found to be 11 MPa, corresponding to an optimum working-fluid flowrate of 6.5 kg/s. The longer the DHE, the greater the corresponding working-fluid flowrate and the higher the net power output. For geofluid temperature ranging from 110 °C to 170 °C, the developed NPC has a better thermodynamic performance than the conventional ORC. The advantage of using the developed NPC becomes obvious when geofluid temperature is low. The maximum net power output difference between the NPC and the ORC happens when the geofluid temperature is 130 °C and NPC’s working fluid mass fraction (R32/CO2) is 0.5/0.5.