The use of an exchange guide wire in coronary angioplasty.

Abstract

Listen

Translate article

Of 84 consecutive patients referred for coronary angioplasty, an exchange length (260 cm) guide wire was used in 17 (20%) to allow serial passage of different sized dilatation catheters. Exchanges were performed for the following reasons: 1) inability to cross the stenotic segment with a full-sized dilatation catheter, with exchange for a smaller catheter to permit initial dilatation followed by a second exchange to reintroduce the full-sized balloon catheter; 2) premeditated initial use of a low-profile balloon catheter in severe stenosis, with subsequent exchange to a full-sized balloon catheter; 3) inability to achieve a satisfactory reduction of the transstenotic gradient or angiographic stenosis with the initial dilation catheter, requiring subsequent passage of a larger balloon catheter into the partially dilated segment. Eighteen of 19 attempted exchanges and 18 of 19 angioplasty procedures were completed successfully. The use of exchange guide wires permits multiple recrossings of a dilated segment, allows safe serial passage of different sized balloon catheters, and obviates the need for renegotiating difficult proximal coronary anatomy. The exchange guide wire techique can be applied safely and effectively to coronary angioplasty and provides an additional option in the successful completion of movable guide wire angioplasty procedures.