Abstract

AbstractThe Teena Zn-Pb deposit is located in the Carpentaria Zn Province (Australia), which contains some of the largest clastic dominant (CD-type) massive sulfide Zn-Pb deposits in the world. The timing of the main stage of hydrothermal sulfide mineralization in the Teena subbasin is constrained to the midstage of burial diagenesis, during a period of short-lived regional extension. To distinguish hydrothermal alteration from spatially and temporally overlapping burial diagenetic alteration, and to establish the primary controls on hydrothermal mass transfer, it is necessary to evaluate the various foot- and hanging-wall alteration assemblages that formed between early- (eogenesis) and late- (mesogenesis) stage diagenesis. To achieve this, we have statistically evaluated a large lithogeochemistry dataset (n >2,500) and selected a subset (n = 65) of representative samples for detailed mineralogical (X-ray diffraction, illite crystallinity) and petrographic (scanning electron microscopy) analyses; hyperspectral core imaging data were then used to upscale key paragenetic observations.We show that sulfide mineralization was predated by multiple diagenetic alteration assemblages, including stratiform pyrite, dolomite nodules and cement, disseminated hematite and authigenic K-feldspar. These assemblages formed during eogenesis in multiple subbasins across the broader McArthur Basin and are not part of the synmineralization alteration footprint. Whereas pyrite and dolomite formed primarily from the in situ degradation of organic matter, feldspar authigenesis was the product of K metasomatism that was focused along permeable coarse-grained volcaniclastic sandstone beds within the host-rock sequence. The immature volcaniclastic input is broadly representative of the siliciclastic compositional end member in the subbasin, which formed the protolith for phyllosilicate (illite, phengite, chlorite) formation during burial diagenesis. There is no evidence of extensive phyllosilicate alteration in any of the geochemical, mineralogical (illite crystallinity), or petrographic datasets, despite some evidence of K-feldspar replacement by sphalerite in the Lower and Main mineralized lenses. Rather, the high Zn grades formed via dolomite replacement, which is resolvable from a chemical mass balance analysis and consistent with petrographic observations.There are significant exploration implications associated with carbonate-replacement sulfide mineralization during mesogenesis: (1) the capacity for secondary porosity generation in the host rock is as important as its sulfate-reducing capacity; (2) hydrothermal mineralization has a short-range cryptic lateral and vertical synmineralization alteration footprint due to acid neutralization by a carbonate-rich protolith; and (3) the distribution and chemistry of premineralization phases (e.g., pyrite, dolomite nodules) cannot be directly related to the mineralization footprint, which is localized to the 4th-order subbasin scale. Future exploration for this deposit style should therefore be focused on identifying units that contain a mixture of organic carbon and carbonate in the protolith, at favorable stratigraphic redox boundaries, and proximal to feeder growth faults.

Highlights

  • Some of Earth’s largest base metal resources are associated with clastic-dominant (CD-type) massive sulfide deposits (Mudd et al, 2017)

  • A correlation matrix for the entire principal component analysis (PCA) dataset (n = 2,705; sampling protocols 1 and 2) highlights some important correlations between the major elements (Table 1; the compositional data for the samples from protocol 2 are presented in Magnall et al, 2021)

  • The concentrations of the main sulfide minerals can be calculated from total S (i.e., FeS2 = 0.5 * and ZnS or PbS = total S – [2 * FeS2]). The calculation of these sulfide mineral concentrations assumed that no other sulfide phases are present, which is confirmed by petrography and XRD results

Read more

Summary

Introduction

Some of Earth’s largest base metal resources are associated with clastic-dominant (CD-type) massive sulfide deposits (Mudd et al, 2017). These mineral systems can be very large (102 Mt ore) and high grade (>10% combined Zn + Pb), yet they are difficult to predict and detect in the terrestrial rock record. The capacity of exploration programs to detect mineralized rocks is dependent on accurate mineral system models that describe the alteration footprint of deposits. The prevailing model for many CD-type deposits involves sedimentary exhalative (SEDEX) processes, whereby layered sulfide minerals formed when hydrothermal fluids vented into sulfidic (euxinic) seawater (e.g., Goodfellow et al, 1993).

Methods
Results
Discussion
Conclusion

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.