The synergism of peak to peak value, frequency and superimposed DC bias voltage on electric-field-induced strain of PZT based-macro fiber composites

Abstract

The macro fiber composites (MFCs) with uniform and repeatable electromechanical performance have been a popular choice in various applications like structural actuation, vibration control, structural health monitoring, and energy harvesting. Herein, the strains of lead zirconate titanate based MFCs subjected to various driving signals were conducted via the strain-electrometry method. The formation mechanism of the strains was profoundly expounded, and the variation of the strains as a function of peak to peak value, frequency and superimposed DC bias voltage was further explored. The results demonstrate that both longitudinal and transverse strain-voltage curves with the voltage cyclic loading are closed “ellipse-like” hysteresis loops, in which the strain of ascending branch is smaller than that of the descending branch. Both strains increase with increasing the peak to peak value of driving signal and the increase is more remarkable at smaller bias voltage and lower frequency, while decrease with increasing the positive DC bias voltage and the decrease is specially obvious at larger peak to peak value and lower frequency. Besides, the dispersive effect of the strains induced by larger peak to peak value, particularly with smaller superimposed bias voltage, is more apparent than that induced by smaller peak to peak value. The longitudinal and transverse strains of MFCs with an active area of 40 mm × 30 mm range from 74.8 με to 1688.3 με, and 20.3 με to 488 με, respectively. This research indicates that through properly and carefully synthetical modulation of electrical parameters of driving signal, a notably enhanced strain can be achieved in MFCs for the specific applications such as actuation and high frequency structural control.