Abstract
The article deals with the research of the pressures originated inside the cooling system and also in the mould cavity during the injection moulding process. The simulations were realized for three designed types of running system and for four versions of cooling system. 3D model of the mould was created in Autodesk Inventor Proffesional software and then solidification of material was simulated in Autodesk Moldflow Insight software. The results were compared and the best version from the view of pressure was manufactured and placed into the injection moulding machine Arburg Allrounder 320 C.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.