The s-version finite element method for non-linear material problems

Abstract

This study intended to extend the s-version of the finite element method (s-version FEM) to cope with elastic–plastic problems. Compared with the conventional FEM, the s-version FEM, which overlays a set of local mesh with fine element size representing irregular features over the conventional FE mesh with coarse element size, can considerably simplify issues in domain discretisation with fewer degrees of freedom and provide accurate numerical predictions. However, most applications of the s-version FEM were limited to elastic problems only, leaving its applications to elastic–plastic problems almost blank owing to insufficient instructions on stress update when plasticity sets in. To address these issues, detailed instructions and formulations to cope with plasticity problems with the s-version FEM were presented for its first time. The recursive element subdivision technique was implemented to generalise its application where local elements intersect with global element edges. A 3D stress concentration problem with linear/non-linear material properties was analysed; their numerical results were compared with the exact solutions and those obtained from the conventional FEM with very fine elements. The comparison highlights the flexibility of the s-version FEM in domain discretisation and its superior accuracy in numerical calculations, thereby exhibiting high potential applications in structural integrity assessment with complex structures, geometric defects, and material non-linearity.