Abstract
The Deep Creek Lake Study of 1983 provided an opportunity to obtain emission samples from coal-fired power plants with a dilution sampler for mutagenicity testing. Stack and ambient samples of particulate matter were collected with a dilution sampler at three coal-fired power plants in West Virginia. Samples were sequentially extracted with cyclohexane (CX), dichloromethane (DCM) and acetone (ACE) and tested for mutagenicity in the Ames Salmonella/microsome assay using TA98 (-S9). For the stack samples, the CX, DCM and ACE fractions constituted 1.0, 0.7 and 98.1 percent of the total extractable organic material (EOM), respectively, compared to 28.5, 7.4 and 64.1 percent for the ambient samples. In contrast, the mutagenic activity of the organic fractions was concentrated in the CX and DCM fractions. The cyclohexane- and dichloromethane-soluble fractions of the stack samples from all locations exhibited mutagenicity when tested in the plate incorporation assay. No significant response was observed with the acetone fraction. When tested with Kado's modification of the preincubation assay, the acetone-soluble fraction did exhibit mutagenic activity comparable to that of the other fractions when expressed in units of revertants per milligram of particular matter. Chemical analyses of one of the acetone-soluble fractions indicated that half of the mass was sulfuric acid while the remainder consisted of C, H and O. More than 30 peaks were detected in the high pressure liquid chromatogram of this fraction. Although little mutagenic activity was detected in the polar ACE fraction of the diluted stack emissions samples with this single bioassay, in view of the large mass of this fraction, further investigation of the chemical composition and genotoxic activity of this fraction would be prudent.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.