Abstract
The motion paths of Balanus reticulatus cyprids were similar on all the titanium alloys surfaces. On the parallel grinding surfaces, the temporary attachment duration and the settlement ratio of the cyprids were influenced by the roughness and the composition of the surfaces and correlated positively. The surface roughness could also change the contact area and the numbers of the attachment points of the cyprids in the similar pattern. Consequently, the roughness and the composition of the surfaces regulated the cyprid settlement by the temporary attachment duration. The cross grinding increased the temporary attachment duration but drastically decreased the settlement ratio to 0 compared to the parallel grinding, possibly due to the voids and the drastic decrease of the contact area and the numbers of the attachment points of the cyprids on the cross grinding surface, respectively. The cross grinding therefore significantly reduced the cyprid settlement compared to the parallel grinding.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
