Abstract
Improving the engineering properties of A356 alloy is an appealing option for the automotive industry. This study aimed at refining and redistributing Si particles and the eutectic phase by applying T6 heat treatment to a semi-solid A356 alloy, followed by severe plastic deformation (SPD). Using a cooling-slope technique, the as-cast and rheocast samples were subjected to heat treatment prior to being processed using equal-channel angular pressing (ECAP) and high-pressure torsion (HPT) at room temperature. The results show that the brittle Si particles were effectively fragmented and redistributed in the homogenous microstructure. The grain size reduced from 170 μm to 23 μm in the as-cast sample after combining heat treatment and the cooling-slope. This was followed by the ECAP sample after six passes through route A (where the sample is not rotated between each pass), while it reduced to 160 nm after five turns of the HPT process in a heat-treated cooling-slope sample. The hardness of the heat-treated cooling-slope casting samples increased with the ECAP process; there was an increase from 61 HV to 134 HV for the as-cast alloy after six passes through route A. The hardness of the heat-treated cooling-slope sample improved with the HPT process to 211 HV after five turns.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
