Abstract
Experimental results obtained during oblique cutting of annealed steel Ck 45 (SAE-AISI 1045) with a single-edged tool are presented. Extensive measurements of forces, cutting ratio, chip flow angle etc. have been carried out under a wide range of cutting conditions. The measured data obtained from these cutting tests are used to test assumptions proposed in the first part of this work. In relation to previous works dealing with oblique cutting problems the present one extends to tools with angles of tool obliquity ranging from 30° to 70° and having a large negative rake angle.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: International Journal of Machine Tools and Manufacture
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
