Abstract
It has been noted that the chip formation mechanism in metal cutting with edge tools with a large negative rake angle γ is not fully understood. Methods for assessment of some chip formation characteristics are put forward and examples are given of how they are implemented during the comparison between calculated and experimental values for the case of cutting lead workpieces using tools with a rake angle γ ranging from zero to −60°.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
