The Measurement of Compressive Creep Deformation and Damage Mechanisms in a Single-Phase Alumina Part I Grain boundary sliding

Abstract

Grain boundary sliding (GBS) has been hypothesized to act as the primary driving force for the nucleation and growth of grain boundary cavities in ceramics undergoing creep. In addition, GBS is often a major mode of deformation during high-temperature creep. This paper demonstrates the importance of GBS with mode II GBS measurements performed using a stereoimaging technique on a single-phase alumina tested under constant compressive stresses of 70 and 140 MPa at 1600 °C. Measurements were taken at constant time intervals during creep. The results support previous observations that GBS is stochastic and history independent. GBS displacements at given time intervals are shown to fit a Wiebull distribution. During steady-state creep, GBS displacements increased linearly with time at a constant sliding rate of ≈ 6.0 × 10−5 μm s−1 at 70 MPa and ≈ 1.3 × 10−4 μm s−1 at 140 MPa. Also, an average of 67% of the grain boundaries exhibited measurable sliding throughout the creep life of the 140 MPa test. Results of the GBS measurements are used to modify an existing creep model describing stochastic GBS. In part II of this paper [1], the GBS measurements reported are related to the associated creep cavitation measured in specimens tested under identical conditions.