The inhomogeneous MUSIG model for the simulation of polydispersed flows

Abstract

A generalized inhomogeneous multiple size group (MUSIG) model based on the Eulerian modeling framework was developed in close cooperation of ANSYS-CFX and Forschungszentrum Dresden-Rossendorf and implemented into the CFD code CFX. The model enables the subdivision of the dispersed phase into a number of size groups regarding the mass balance as well as regarding the momentum balance. In this work, the special case of polydispersed bubbly flow is considered. By simulating such flows, the mass exchanged between bubble size classes by bubble coalescence and bubble fragmentation, as well as the momentum transfer between the bubbles and the surrounding liquid due to bubble size dependent interfacial forces have to be considered. Particularly the lift force has been proven to play an important role in establishing a certain bubble size distribution dependent flow regime. In a previous study [Krepper, E., Lucas, D., Prasser, H.-M., 2005. On the modeling of bubbly flow in vertical pipes. Nucl. Eng. Des. 235, 597–611] the application of such effects were considered and justified and a general outline of such a model concept was given. In this paper the model and its validation for several vertical pipe flow situations is presented. The experimental data were obtained from the TOPFLOW test facility at the Forschungszentrum Dresden-Rossendorf (FZD). The wire-mesh technology measuring local gas volume fractions, bubble size distributions and velocities of gas and liquid phases were employed. The inhomogeneous MUSIG model approach was shown as capable of describing bubbly flows with higher gas content. Particularly the separation phenomenon of small and large bubbles is well described. This separation has been proven as a key phenomenon in the establishment of the corresponding flow regime. Weaknesses in this approach can be attributed to the characterization of bubble coalescence and bubble fragmentation, which must be further investigated.