Abstract

The Daguangbao (DGB) landslide was the largest landslide that was triggered by the 2008 Wenchuan earthquake with a magnitude of Ms8.0. The sliding surface of this landslide was constrained on a bedding fault 400 m below the ground surface. Seismic records show that the landslide suffered not only from strong horizontal but also vertical ground shaking that was almost equal to the horizontal component. In this study, to reveal the landslide triggering mechanism of the DGB landslide, this study ignores the steep dipping tension fracture section and the leading edge-locking section of the trailing edge of the DGB landslide, and the geological model of the large optical package landslide is generalized into a block model with the bottom controlled slip soft zone as the interface. Based on the improved Newmark method that considers vertical ground motion, the three-way seismic acceleration data and the shear strength parameter of the sliding surface being taken as a variable are used to calculate the cumulative permanent displacement of the slider. Then, by considering the cumulative permanent displacement ratio of vertical seismic acceleration or not and the cumulative permanent displacement ratio value considering the inertial force as the index, the response characteristics of the cumulative permanent displacement of the block-to-vertical ground motion and inertial forces were analyzed. The results show that both the horizontal inertial force and the vertical acceleration significantly increased the permanent displacement. The permanent displacement is 4.9 cm when considering the vertical acceleration, whereas it is only 2.0 cm without taking this into account. The contribution of vertical acceleration is significantly enlarged (87.8–90.7%) by the decreasing of the internal friction angle of the slide surface, while it is less influenced (5–27.4%) by the cohesion. Compared with the lower shear strength parameter of the sliding surface, the contributions of vertical acceleration and inertial force to the permanent displacement are more obvious when the shear strength parameter of the sliding surface is higher. When ϕ > 18°, the D/D* is greater than 1, and the maximum D/D* reaches 7. The fast accumulation event of permanent displacement is triggered in the concentration stage of the seismic energy release. In the DGB landslide area, 50% of the energy is released within 30–50 s, as indicated by the acceleration peaks recorded at the nearest seismic station, Qingping station. It is assumed that the DGB landslide may be triggered at 30–50 s due to half of the seismic energy being released during that time span.

Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call