Abstract
This paper reports influence of isothermal aging on bulk solder and the microstructure evolution of commercial Sn-0.7Cu (Sn-0.7Cu-0.05Ni+Ge) Pb-free solder alloy with addition of bismuth (Bi) and indium (In). Sn-0.7Cu, Sn-0.7Cu-1.0Bi, Sn-0.7Cu-1.0Bi-1.0In, Sn-0.7Cu-1.0Bi-4.0In, Sn-0.7Cu-1.0Bi-7.0 In solder alloys were prepared via casting process. The solder alloys were aged isothermally at 180°C for 500 hours and microstructure was compared with that of as-cast solder. Microstructure of bulk solder and melting temperatures were analysed via scanning electron microscopy, SEM and differential scanning calorimetry, DSC. The addition of In up to 7 wt% reduced the melting temperature from 231.1 to 218.5°C, and crystallisation temperature from 205.8 to 194.7°C with decreasing degree of undercooling which indicates that the In-added solder alloy had faster nucleation rate. Microstructure evaluation showed that as the amount of indium added increased to 7.0 wt%, the ß-Sn grains became smaller suggesting a refinement effect with In addition. Indium addition also encouraged the formation of Sn-In and Bi-In IMC which increased as the amount of In increased. These IMCs could potentially act as blocking mechanism for deformation leading to higher strength.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a call