Abstract
Polymer blend consist of epoxy and polymethylmethacrylate (PMMA) was prepared via two different blending methods. Conventional blending method which required solvent to obtain polymer blend of PMMA and epoxy. However, due to the high consumption of solvent and environmental issue, a new approaching method: direct mixing method was used to prepare the polymer blend without the usage of solvent. The PMMA pellets are grinded and sieved into fine powders and incorporated into epoxy. Comparison between the conventional and new method was done through the investigation based on the morphology and mechanical behaviour, with different PMMA content (0, 10, 20, 30, 40 and 50 vol.%) between two blending methods. In overall, the polymer blend system prepared via direct mixing methods exhibited better mechanical properties as compared to conventional solvent dissolution method. Improvement on fracture toughness was observed in direct mixing method.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
