Abstract
Ultraflne titanium dioxide powder was synthesized by the gas-phase oxidation of titanium tetrachloride in a multistage aerosol reactor. The reactor consisted of three zones: an evaporation zone for TiCl4, a preheating zone for oxygen and vaporized titanium tetrachloride, and a reaction zone. Preheating temperature of reactants, partial pressure of reactants, and temperature in the reaction zone were chosen as experimental variables for the control of particle size and distribution. Ultratine TiO2 powders ranging from 30 to 70 nm in average particle sizes were produced. The preheating temperature of reactants was found to be an effective factor for particle size and distribution of ultraflne powders. As the preheating temperature was increased, average particle size became smaller and size distribution more uniform. Larger particles having narrow size distributions were produced with an increase in TiCl4 mole fraction under the control of preheating temperature. However, variation of O2 mole fraction did not show much difference on the average particle size. As the temperature in the reaction zone was increased, average particle size became smaller. With the decrease in the residence time of reactants in the reaction zone smaller particles were obtained.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.