The effects of laser peening and shot peening on fretting fatigue in Ti–6Al–4V coupons

Abstract

This paper describes testing of Ti–6Al–4V coupons in fretting fatigue and compares the effects of mechanical surface treatments on performance. Fretting fatigue tests were performed using a proving ring for fretting load, bridge-type fretting pads, and applied tension–tension cyclic fatigue stress. As-machined (AM), shot peened (SP), and laser peened (LP) coupons were evaluated, and data generated to compare residual stress, surface condition, lifetime, and fractographic detail encountered for each. Near-surface residual stress in SP and LP coupons was similar. The layer of compressive residual stress was far deeper in LP coupons than in SP coupons and, consequently, subsurface tensile residual stress was significantly greater in LP coupons than in SP coupons. SP coupons exhibited a rough surface and had the greatest volume of fretting-induced wear. LP coupons exhibited a wavy surface and had a small volume of wear localized at wave peaks. SP coupons had the greatest fretting fatigue lifetime, with significant improvement over AM coupons. Lifetimes of LP coupons were similar to those for SP coupons at high fatigue stress, but fell between AM and SP coupons at lower fatigue stress. Fractographic evaluation showed that fractures of AM samples were preceded by initiation of fretting-induced cracks, transition of a lead fretting crack to mode-I fatigue crack growth, and crack growth to failure. SP and LP samples exhibited behavior similar to AM samples at high fatigue stress, but in coupons tested at low stress the lead crack initiated subsurface, near the measured depth of maximum tensile residual stress, despite the presence of fretting-induced cracks. The level of fatigue stress above which lead cracks were initiated by fretting was higher for LP than for SP, and was predicted with good accuracy using an analysis based on linear elastic fracture mechanics, the fatigue crack growth threshold stress intensity factor range, and superposition of measured residual stress and applied fatigue stress.