Abstract

The effects of gas and liquid inlet geometry on adiabatic gas-liquid two-phase flow in a microchannel of 100 micron diameter have been investigated using different inlet sections and methods of gas and liquid injection and mixing. Two-phase flow patterns, void fraction and friction pressure drop were found to be significantly affected by the diameter of the inlet section and how the gas and liquid phases are injected and mixed upstream of the microchannel. Using a tee junction of the same diameter as the microchannel as the inlet, the two-phase flow pattern in the microchannel is mostly intermittent with short gas and liquid slugs flowing with nearly equal velocities. The void fraction then conforms nearly to that of a homogeneous two-phase flow, and two-phase friction multiplier applicable to larger channels is obtained. However, when the diameter of the inlet section is larger than the microchannel, the two-phase flow characteristics in the microchannel become highly dependent on the flow characteristics in the inlet section. Long gas slugs become prevalent and the void fraction decreases to values far below those given by a homogeneous void fraction. The practical implications for designing microchannel devices utilizing gas-liquid two-phase flow will be described.Copyright © 2005 by ASME

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.