Abstract
The present work investigates the effects of geometry and laser power on the porosity and melt pool formation for 316L stainless steel samples fabricated using the laser powder bed fusion (LPBF) technique. Both cylindrical and conical parts with the same heights were processed at a range of laser powers (60–70 W). An analytical model was used to select a suitable laser power, based on the established processing parameters, but also to predict the resultant melt pool dimensions. Based on the combination of experimental work and mathematical modelling, a novel geometrical factor is proposed, which was demonstrated to successfully improve the implemented model. A decrease in melt pool depths towards the building direction was determined in all the printed samples; this was however not predicted by the mathematical model. Furthermore, the variation in heat extraction exhibited by the conical and cylindrical parts allows the correlation between the melt pool dimensions and the geometrical factor. Finally, the influence of conical and cylindrical shapes on part hardness with increasing distance from the build plate was demonstrated; based on this comparison, it was determined that the cone geometries exhibit both a higher Vickers hardness and density.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: The International Journal of Advanced Manufacturing Technology
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
