The Effect of Stocking Temperature on Biodegradable Plastic Characteristics of Suweg Tuber (Amorphophallus campanulatus) with Addition of Glycerol and CMC (Carboxy Methyl Cellulose)

Abstract

Listen

Translate article

Research that uses Suweg tubers as the basic material for making biodegradable plastics has been carried out.. This research aims to determine the effect of stirring temperature on the characteristics of biodegradable plastic. Suweg tuber starch preparation is done as the manufacture of biodegradable plastic. Manufacture of biodegradable plastics made by mixing suweg tuber starch, glycerol, and acetic acid, as well as the CMC (Carboxy Methyl Cellulose). The manufacture of biodegradable plastic is carried out in two stages, namely stirring temperature variations (80⁰C, 85⁰C, 90⁰C, and 95⁰C) and the addition of CMC (Carboxy Methyl Cellulose). Tests carried out include FTIR test, mechanical test and biodegradation test. FTIR test is carried out to determine the functional groups contained in plasticThe test of plastic mechanical properties was carried out to determine the mechanical properties of plastics, such as tensile strength, elongation, and thickness. Biodegradation tests are carried out on the ground to determine the level of plastic degradation while in the environment. The results showed that the effect of temperature affected the mechanical properties of biodegradable plastic produced. Mechanical tests of stirring temperature variations with the addition of glycerol resulted in tensile strength, elongation, and thickness values of 80⁰C at 10.43 MPa; 2.08%; 85⁰C at 28.52 MPa; 1.60%, 90⁰C of 29.76 MPa; 2.18%, and 95⁰C of 32.49 MPa; 2.05%. These results can be seen that the largest biodegradable plastic tensile strength is found in temperature variations of 95⁰C, with a tensile strength of 32.49 MPa elongation 2.05%, and a thickness of 0.12 mm.. Mechanical properties test of temperature variation with the addition of glycerol and CMC resulted in the value of tensile strength, elongation, and temperature thickness of 80⁰C at 18.68 Mpa; 12.22%, 85⁰C equal to 14.69 MPa; 9.16%, 90⁰C of 16.71 MPa; 14.72%, 95⁰C of 13.94 MPa; 14.166%. These results can be seen that the largest biodegradable plastic tensile strength is found at 80⁰C temperature variations of 18.68 MPa, 12.22% elongation, 0.14 mm thickness. FTIR test, the biodegradable plastic produced, it is known that the plastic group produced is like CH, ester or ether. Plastic bio degradation test on soil, plastic with a temperature variation of 95⁰C has been degraded after 8 days, while plastic with the addition of CMC is degraded faster, for 7 days.