Abstract
Since some adverse effects of using carbon black as petroleum-based filler in rubber compounding, mineral fillers may be a feasible alternative filler. This research studied the effect of the composition of pumice and clay as mineral filler in natural rubber (NR) and ethylene propylene diene monomer (EPDM) blending towards its curing characteristics and physical-mechanical properties. The effect of reinforced filled in EPDM-NR (70/30) phr blends was observed by varying 50, 70, and 90 phr of filler. While the filler was designed as the composition of pumice/clay (P/C): 20/80; 50/50; 80:20 (weight/weight). The rubber, fillers, and chemical were compounded based on ASTM D-3182. The results showed that the loading of P/C fillers in EPDM-NR blends increased scorch time and decreased cure rate index. It was found that the optimum number of filler could enhance density, modulus. Remarkably, the higher pumice composition caused the abrasion resistance and compression set improved significantly, whereas the overloading pumice and clay cause the physic-mechanical properties remained stable or evenly drop. FTIR spectra of the binary blends confirmed that the fine fillers dispersion was obtained due to some interaction bonding between silanol, aluminol of fillers with the EPDM-NR.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: IOP Conference Series: Materials Science and Engineering
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
