Abstract
This paper focused on the effect of in-process cooling conditions (coolants and flow rate) on the temperature history, the tool applied forces, wear resistance, mechanical, and microstructural properties of friction stir processing (FSP) of Al–Si aluminum alloy. FSP was carried out using different compressed air and water coolants with different flow rates. The FSP tool force was measured experimentally using an especially designed load measuring system. Optical microscopy was used to probe the microstructures of the FSPed samples. The results showed that the Si particles size significantly decreases with increasing in-process cooling rate. Mechanical properties of each FSPed sample were also determined using hardness tests. Finally wear tests were conducted using a pin-on-disk tribometer.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Proceedings of the Institution of Mechanical Engineers, Part L: Journal of Materials: Design and Applications
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
