The effect of hydrogen charging on the evolution of lattice defects and phase composition during tension in 316L stainless steel

Abstract

The effects of hydrogen charging on the evolution of strain-induced lattice defects and phase transformation were investigated in 316L stainless steel. The initial material was obtained by cold rolling to a thickness reduction of 20%. The surfaces of some of the initial samples were cathodically charged with hydrogen. Afterward, both the charged and uncharged samples were subjected to tension until failure. The dislocation density and twin-fault probability in the charged and uncharged specimens during tension were compared. We found that hydrogen charging reduced the degree of increase in the dislocation density and twin-fault probability during the application of tension to the same strain level. Significant martensitic phase transformation was observed in the uncharged samples tested to the strain of 10% or higher. In the hydrogen-charged samples, only a slight increase in the martensite phase fraction was detected. A correlation between the α′-martensite fraction and the dislocation density was found for the studied samples, suggesting that the lower degree of martensitic phase transformation in the charged 316L steel was caused by the smaller amount of stress developed due to the lower dislocation density. In accordance with the differences observed in the phase composition and defect densities, the hydrogen-charged material exhibited lower surface hardness.