The Effect of Endodontic Irrigants on the Microtensile Bond Strength of Dentin Adhesives

Abstract

Introduction The purpose of this study was to evaluate the microtensile bond strength of a total etch (XP-Bond) and a self-etch (Clearfil SE Bond) adhesive system to dentine surfaces treated using endodontic irrigants. Methods Twenty-four freshly extracted third molars were used. After creating a smear layer on the coronal midthird portion of the crowns, the teeth were divided into three groups and surfaces were irrigated with distilled water, 5.25% NaOCl + 17% EDTA, and 1.3% NaOCl + BioPure MTAD, respectively. Each group was divided into two subgroups, and a self-etching adhesive and an etch-and-rinse adhesive were applied respectively. The teeth were restored with a composite material and sectioned to produce sticks for microtensile bond testing. Results The microtensile bond strength of the MTAD + Clearfil SE group was found to be significantly lower than the microtensile bond strength of the distilled water + Clearfil SE Bond group and the NaOCl, EDTA, + Clearfil SE Bond group (p = 0.0001, p = 0.009). Conclusions Because of the significant reduction of Clearfil SE Bond to coronal dentine after MTAD application, an etch-and rinse adhesive such as XP-Bond may be preferred if this irrigant has been chosen during endodontic treatment.