The effect of drip line placement on yield and quality of drip-irrigated processing tomatoes

Abstract

Subsurface drip irrigation of processing tomatoes is increasing in California. The common design approach is to bury drip lines 0.2–0.36 m deep in the middle of the plant row, which places drip lines directly beneath plant rows. This design limits the use of the drip irrigation system to only those crops compatible with this drip line and bed spacing, and thus, other design approaches are being investigated to increase the flexibility of the drip systems. These approaches are installing drip lines in alternate furrows and installing drip lines in every furrow, both of which place drip lines midway between plant rows. The furrows are the result of the cultural practices used to form beds for planting.This study investigated the effect of the different drip line placements on crop yield and quality. Results showed that the highest yields occurred for the buried placement and the smallest yields for the alternate furrow placement. For the buried placement, soil water content and root density were concentrated around the drip lines, directly beneath the plant rows, while for the furrow placements, zones of high soil water content and root density did not coincide with the plant rows. However, some growers have found the furrow placement to reduce some of the disease problems normally experienced with the traditional furrow irrigation methods.