The Effect of Different Vegetation Restoration Types on Soil Quality in Mountainous Areas of Beijing

Abstract

Soil quality is a very important indicator used to assess ecosystem restoration states in terms of vegetation recovery and establishment. Evaluating the soil quality of different vegetation restoration types in mountainous areas of Beijing and identifying their influencing factors would provide a scientific basis and be helpful for vegetation restoration in the future. Six vegetation types (or communities), including Platycladus orientalis (L.) Franco pure forest (POP), Pinus tabulaeformis Carr. pure forest (PTP), Platycladus orientalis–Pinus tabulaeformis mixed forest (PPM), Platycladus orientalis coniferous and broadleaved mixed forest (POCB), Pinus tabulaeformis coniferous and broadleaved mixed forest (PTCB), deciduous broadleaved mixed forest (DBMF), and one area of non-afforested land (NF), with similar stand conditions were selected and fourteen factors of soil physical and chemical characteristics were measured and used to establish a total data set (TDS), while a minimum data set (MDS) was obtained by using the principal component analysis (PCA) and Pearson correlation analysis methods. Two scoring methods, linear (L) and non-linear (NL), were used to calculate the soil quality index (SQI), and the key factors influencing soil quality by vegetation were identified by a general linear model (GLM), PCA, and correlation analysis. The results showed that: (1) The screened MDS indicators which showed good relationships with the SQIs in the study areas were total nitrogen (TN), sand content, total potassium (TK), pH, and available water capacity (AWC). The SQI–NLM method has better applicability. (2) The contribution rates of vegetation to different soil factors accounted for 28.644% (TN), 21.398% (sand content), 24.551% (TK), 16.075% (pH), and 9.332% (AWC). (3) TN showed a positive relationship with all vegetation types; the content of TN in PTCB and DBMF was obviously larger than in the other types in the 0–10 cm layer; PPM, PTCB, and POCB affected the sand content, which showed negative correlativity; and DBMF showed positive correlativity with AWC. The mechanism of how different species affect TN, sand content, and AWC should be focused on and taken into consideration in further studies.