Abstract
AbstractThe corrosion behavior of 310S austenitic stainless steel, subjected to different surface treatments machined (MA), sandblasting (SB), and polishing (PO), was exposed to a 550°C supercritical water (SCW) environment. The aged samples were analyzed using variable‐energy slow positron beam techniques. The obtained results revealed that the plastic deformation of the near‐surface region of the MA and SB samples was substantially recovered in the SCW conditions. At least two distinct oxide layers formed, and the oxidation process created a Fe/Cr depletion zone in the inner layer. Various surface treatments, however, led to different corrosion profiles. The depth profile of slow positron beam characterization suggests that significant residual stress and deformation zones on the surfaces of the sandblasted samples probably provided a diffusion path for the oxidation of the 310S. Only the SB samples exhibited a negative weight change after SCW exposure. At the same time, the SB samples showed the highest concentration of the positron traps in this region, which was explained by open‐volume defects associated with the microcracks introduced by sandblasting.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
