Abstract
By use of a blowing agent bubbles of a few hundred microns diameter were introduced at the interface of copper and steel substrates coated with low density polyethylene. The presence of the bubbles leads to an improvement in peel strength. An explanation is put forward in terms of a suggested stress perturbation produced by the bubbles which leaves the interface itself relatively lowly stressed and leads to the expenditure of work in plastic deformation of the polymer away from the interface. Support for the explanation was obtained by photoelastic study of a model system and by scanning electron microscopy of the peeled surfaces.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.