The effect of an orthopedic specialty hospital on operating room efficiency in shoulder arthroplasty

Abstract

Operating room (OR) time is a major cost to the health care system. Therefore, increasing OR efficiency to save time may be a cost-saving tool. This study analyzed OR efficiency in shoulder arthroplasty at an orthopedic specialty hospital (OSH) and a tertiary referral center (TRC). All primary shoulder arthroplasties performed at our OSH and TRC were identified (2013-2015). Manually matched cohorts from the OSH and TRC were compared for OR times. Three times (minutes) were recorded: anesthesia preparation time (APT; patient in room to skin incision), surgical time (ST; skin incision to skin closed), conclusion time (CT; skin closed to patient out of room). There were 136 primary shoulder arthroplasties performed at the OSH and matched with 136 at the TRC. OSH and TRC patients were similar in age (P = .95), body mass index (P = .97), Charlson Comorbidity Index (P = 1.000), sex (P = 1.000), procedure (P = 1.000), insurance status (P = .714), discharge destination (P = .287), and diagnoses (P = .354). These matched populations had similar ST (OSH: 110.0 ± 26.6 minutes, TRC: 113.4 ± 28.7 minutes; P = .307). APT (39.2 ± 8.0 minutes) and CT (7.6 ± 3.8 minutes) were shorter in the OSH patients than APT (46.3 ± 8.8 minutes; P < .001) and CT (11.2 ± 4.7 minutes; P < .001) in TRC patients. Total nonoperative time (sum of APT and CT) at the OSH (46.8 ± 8.9 minutes) was shorter than at the TRC (57.5 ± 10.4 minutes; P < .001). Despite similar patient populations and case complexity, the OR efficiency at an OSH was superior to a TRC. Further analysis is needed to determine the financial implications of this superior OR efficiency.