The Dual Method Approach (DMA) Resolves Measurement Range Limitations of Heat Pulse Velocity Sap Flow Sensors

Abstract

Sap flow, the movement of fluid in the xylem of plants, is commonly measured with the heat pulse velocity (Vh) family of methods. The observable range of Vh in plants is ~−10 to ~+270 cm/h. However, most Vh methods only measure a limited portion of this range, which restricts their utility. Previous research attempted to extend the range of Vh methods, yet these approaches were analytically intensive or impractical to implement. The Dual Method Approach (DMA), which is derived from the optimal measurement ranges of two Vh methods, the Tmax and the heat ratio method (HRM), also known as the “slow rates of flow” method (SRFM), is proposed to measure the full range of sap flow observable in plants. The DMA adopts an algorithm to dynamically choose the optimal Vh measurement via the Tmax or HRM/SRFM. The DMA was tested by measuring sap flux density (Js) on Tecoma capensis (Thunb.) Lindl., stems and comparing the results against Js measured gravimetrically. The DMA successfully measured the entire range of Vh observed in the experiment from 0.020 to 168.578 cm/h, whereas the HRM/SRFM range was between 0.020 and 45.063 cm/h, and the Tmax range was between 2.049 cm/h and 168.578 cm/h. A linear regression of DMA Js against gravimetric Js found an R2 of 0.918 and error of 1.2%, whereas the HRM had an R2 of 0.458 and an error of 49.1%, and the Tmax had an R2 of 0.826 and an error of 0.5%. Different methods to calculate sapwood thermal diffusivity (k) were also compared with the kVand method showing better accuracy. This study demonstrates that the DMA can measure the entire range of Vh in plants and improve the accuracy of sap flow measurements.