The design of optimum perforation diameters for pin fin array for heat transfer enhancement

Abstract

Listen

Translate article

A three-dimensional inverse design problem is examined in this work using a general purpose commercial code CFD-ACE+ and the Levenberg–Marquardt Method (LMM) to estimate the optimal perforation diameters of perforated pin fin array based on the desired temperature difference between base plate averaged temperature and ambient temperature (ΔT) and system pressure drop (ΔP). The analysis consists of three cases. In design #1, five design variables are used to estimate the optimal perforation diameters and the objective is to minimize ΔT and ΔP of the pin fin array. In design #2, four design variables are considered to determine the optimal perforation diameters based on the minimization of ΔT and ΔP. In design #3, all the perforation diameters are assumed identical and use only one parameter to determine the optimal perforation diameter based on the minimization of ΔT and ΔP. The numerical design results show that, for all six designs considered here, the designed optimum heat sinks always have the lowest average base plate temperature, it can decrease from 6.3% to 7.3% when compared with the solid pin fin array. Finally, experimental verifications are performed on these heat sink modules and the results indicate that there are good agreements between the experimental and numerical temperature distributions on those heat sinks.