Abstract
In a MW-level and high-power wind power system, the level of current and voltage is easy to exceed the capacity of one switch device, so single boost converter has already can't meet the requirements of system. To solve this problem , for 1.2MW direct drive VSCF wind power system this paper designed a improved and multiplex boost converter , the over-voltage protection circuit branch is inserted into the circuit. The system state equation and control strategy are given, and the input current ripple is analyzed. Finally, in the Matlab environment, build the model of direct-drive wind power generation system to verify the feasibility of this circuit. The results show that: the system can run stably, has high efficiency, low ripple and has a good practical value. DOI : http://dx.doi.org/10.11591/telkomnika.v12i4.5002
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: TELKOMNIKA Indonesian Journal of Electrical Engineering
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
