The calibration of sharp-crested weirs with a horizontal edge used for measuring flows in partially full pipes

Abstract

This paper presents the results of a laboratory study on the discharge capacity of sharp-crested weirs fitted with a horizontal edge in pipes during open-channel flow conditions and clean water used to measure the outflow. Such sharp-crested weirs are mounted in pipes and are used to control the inflow to separators. The stream profile does not correspond to the profile given by Bazin for sharp crested weirs in channels. A desired location of the water level measurement point for flow rate calculations was provided. Discharge curves were identified for three sharp-crested weirs of 0.0465, 0.0634 and 0.0771 m in height, installed in the pipe of 0.1534 m in diameter and inclinations of 0.5 and 1.0%. The discharge curves for weir flow with free nappe does not show a significant effect of the pipe slope on the weir discharge capacity. The non-dimensional formulas for the discharge capacity of the sharp-crested weir were found as general polynomial regressions. The results indicate that the calibrated sharp-crested weir with a horizontal edge placed in a pipe can be used to control the flow. Due to the scale effect, relationships obtained from the calibration cannot be generalised to other pipe diameters and weirs heights than those analysed.