Abstract
The bearing strength of pin loaded woven glass-fiber reinforced epoxy composites was investigated. To understand the effect of manufacturing methods on bearing strength of pin loaded composites, specimens manufactured using Vacuum Assisted Resin Transfer Moulding (VARTM) and Hand Lay-up methods were tested under tensile loading. In addition, the effect of geometrical parameters such as diameter of pin-hole (d), edge distance to pin hole diameter ratio (e/d) and, width to pin-hole diameter ratio (w/d) on the bearing strength of pin loaded composites were studied. It was observed that specimens manufactured using VARTM method sustained more load compared to the specimens manufactured using Hand Lay-up method. Geometrical parameters found to be very effective on failure modes, bearing strength and magnitude of sustained load.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
