The addition of silica nanoparticles on the mechanical properties of dental stone

Abstract

Statement of problemThe current application of nanotechnology in dentistry is limited to nanoparticles incorporated into adhesive systems and composite resins. Dental stone is a widely used material, and the incorporation of silica nanoparticles is still unexplored. PurposeThe purpose of this in vitro study was to evaluate the mechanical properties of dental stone after the addition of silica nanoparticles in different concentrations. Material and methodsA total of 180 specimens were prepared, 90 for each dental stone (Durone and Fuji Rock). For the control group (CG), no silica particles were added, while test group TGnI had silica nanoparticles added to 1 wt%, and test group TGnV had silica nanoparticles added to 5 wt%. The roughness, diametral tensile strength (DTS), and compressive strength were measured 24 hours after the start of spatulation. ResultsThe mean roughness values for Durone were 0.55, 0.36, and 0.28 μm for CG, TGnI, and TGnV; for Fuji Rock, the mean roughness values were 0.47 for CG, 0.31 for TGnI, and 0.35 μm for TGnV. The mean DTS values for Durone were 6.0, 5.1, and 5.0 MPa for CG, TGnI, and TGnV, respectively, and for Fuji Rock, the mean DTS values were 6.4, 5.2, and 4.5 MPa for CG, TGnI, and TGnV, respectively. The mean compressive strength values for Durone were 35.4, 32.7, and 32.4 MPa for CG, TGnI, and TGnV, respectively, and for Fuji Rock, the mean compressive strength values were 42.9, 31.2, and 29.8 MPa for CG, TGnI, and TGnV respectively. ConclusionsSurface roughness was statistically lower for the Durone and Fuji Rock stones (P<.001) when silica nanoparticles were added. The addition of silica nanoparticles did not significantly affect the DTS and compressive strength of Durone compared with CG (P>.05) but did affect the DTS of Fuji Rock when 5 wt% was added and the compressive strength in both concentrations (P<.05).