Abstract

BackgroundCT scans can be used to assess the rotational alignment of the femoral component following total knee arthroplasty (TKA). This is done by calculating the posterior condylar angle (PCA).However, the methods used may not account for the biomechanical functionality of the TKA components. This cadaveric study aimed to determine whether the axis of scanning (mechanical or anatomical) alters the results of PCA calculations.MethodsCT scans of 12 cadaveric adult femora were performed along the anatomical axis and the mechanical axis. The PCA was determined on each CT scan by measuring the relationship of the prosthetic posterior condyles to the surgical epicondylar axis of the femur. The mechanical and anatomical axis groups were further subdivided into best-fit and multi-slice subgroups. As a control, the posterior condylar angle was also calculated on photographic images of each femur. Bland-Altman plots were used to determine the correlation between the PCA values obtained from the different scanning axes and measurement techniques.ResultsThere was no significant difference between the PCA measurements derived from anatomical and mechanical axis CT scans. The Pearson correlation co-efficient also indicated good correlation between the two scanning axes.ConclusionThe axis of scanning does not significantly affect the PCA measurements. Therefore, the measurements may be reliably used for clinical decision-making, regardless of the axis of CT scanning.

Highlights

  • Computed tomography (CT) scans can be used to assess the rotational alignment of the femoral component following total knee arthroplasty (TKA)

  • The points on these plots all lie within the 95% confidence interval (CI) (Best-fit: − 2.078 - 0.8200; Multi-slice: − 1.677 - 0.710), indicating there was no significant difference between the posterior condylar angle (PCA) measurements made on the CT images and control photographs

  • Anatomical vs. mechanical axis PCA measurements on CT images The Bland-Altmann plot comparing the PCA measurements from anatomical vs. mechanical axis CT images (Fig. 7) showed that there was no significant difference between the scanning axes

Read more

Summary

Introduction

CT scans can be used to assess the rotational alignment of the femoral component following total knee arthroplasty (TKA). This is done by calculating the posterior condylar angle (PCA). The methods used may not account for the biomechanical functionality of the TKA components This cadaveric study aimed to determine whether the axis of scanning (mechanical or anatomical) alters the results of PCA calculations. Axial CT scans of the femur, performed perpendicular to the axis of function of the femur (mechanical axis scanning), may be (2020) 2:36 more biomechanically relevant in a painful TKA. No studies have investigated whether there is any difference between PCA measurements derived from anatomical axis scanning vs. mechanical axis scanning, and those derived by the original best-fit technique vs. the newer multislice technique

Objectives
Methods
Results
Conclusion
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call