Testing and numerical modelling of lean duplex stainless steel hollow section columns

Abstract

Stainless steels are employed in a wide range of structural applications. The austenitic grades, particularly EN 1.4301 and EN 1.4401, and their low-carbon variants EN 1.4307 and EN 1.4404, are the most commonly used within construction, and these typically contain around 8%–11% nickel. The nickel represents a large portion of the total material cost and thus high nickel prices and price volatility have a strong bearing on both the cost and price stability of stainless steel. While austenitic stainless steel remains the most favourable material choice in many applications, greater emphasis is now being placed on the development of alternative grades with lower nickel content. In this study, the material behaviour and compressive structural response of a lean duplex stainless steel (EN 1.4162), which contains approximately 1.5% nickel, are examined. A total of eight stub column tests and twelve long column tests on lean duplex stainless steel square (SHS) and rectangular hollow sections (RHS) are reported. Precise measurements of material and geometric properties of the test specimens were also made, including the assessment of local and global geometric imperfections. The experimental studies were supplemented by finite element analysis, and parametric studies were performed to generate results over a wider range of cross-sectional and member slenderness. Both the experimental and numerical results were used to assess the applicability of the Eurocode 3: Part 1-4 provisions regarding the Class 3 slenderness limit and effective width formula for internal elements in compression and the column buckling curve for hollow sections to lean duplex structural components. Comparisons between the structural performance of lean duplex stainless steel and that of other more commonly used stainless steel grades are also presented, showing lean duplex stainless steel to be an attractive choice for structural applications.