Abstract
Nanotubes of ferroelectric lead titanate (PbTiO 3) have been made by a template-assisted method. An equimolar Pb–Ti sol was dropped onto porous alumina membranes and penetrated into the channels of the template. Single-phase PbTiO 3 perovskite nanotubes were obtained by annealing at 700 °C for 6 h. The nanotubes had diameters of 200–400 nm with a wall thickness of approximately 20 nm. Excess PbO or annealing in a Pb-containing atmosphere was not necessary in order to achieve single-phase PbTiO 3 nanotubes. The influence of the heating procedure and the sol concentration is discussed.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.