Temperature dependency of virus and nanoparticle transport and retention in saturated porous media

Abstract

The influence of temperature on virus (PRD1 and ΦX174) and carboxyl-modified latex nanoparticle (50 and 100nm) attachment was examined in sand-packed columns under various physiochemical conditions. When the solution ionic strength (IS) equaled 10 and 30mM, the attachment rate coefficient (katt) increased up to 109% (p<0.0002) and the percentage of the sand surface area that contributed to attachment (Sf) increased up to 160% (p<0.002) when the temperature was increased from 4 to 20°C. Temperature effects at IS=10 and 30mM were also dependent on the system hydrodynamics; i.e., enhanced retention at a lower pore water velocity (0.1m/day). Conversely, this same temperature increase had a negligible influence on katt and Sf values when IS was 1mM or >50mM. An explanation for these observations was obtained from extended interaction energy calculations that considered nanoscale roughness and chemical heterogeneity on the sand surface. Interaction energy calculations demonstrated that the energy barrier to attachment in the primary minimum (∆Φa) decreased with increasing IS, chemical heterogeneity, and temperature, especially in the presence of small amounts of nanoscale roughness (e.g., roughness fraction of 0.05 and height of 20nm in the zone of influence). Temperature had a negligible effect on katt and Sf when the IS=1mM because of the large energy barrier, and at IS=50mM because of the absence of an energy barrier. Conversely, temperature had a large influence on katt and Sf when the IS was 10 and 30mM because of the presence of a small ∆Φa on sand with nanoscale roughness and a chemical (positive zeta potential) heterogeneity. This has large implications for setting parameters for the accurate modeling and transport prediction of virus and nanoparticle contaminants in ground water systems.