Abstract
This paper presents a prediction and evaluation of delamination factor in use of twist drill, candle stick drill and saw drill. The approach is based on Taguchi’s method and the analysis of variance (ANOVA). An ultrasonic C-Scan to examine the delamination of carbon fiber-reinforced plastic (CFRP) laminate is used in this paper. The experiments were conducted to study the delamination factor under various cutting conditions. The experimental results indicate that the feed rate and the drill diameter are recognized to make the most significant contribution to the overall performance. The objective was to establish a correlation between feed rate, spindle speed and drill diameter with the induced delamination in a CFRP laminate. The correlation was obtained by multi-variable linear regression and compared with the experimental results.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: International Journal of Machine Tools and Manufacture
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
