Abstract
In this paper, an approach is developed on Taguchi method to optimize the drilling parameters in drilling carbon fiber-reinforced plastic (CFRP) by the candlestick drill bits. The experimental results indicate that the feed rate (f) and the drill diameter (d) are the most important factors and the spindle speed (S) is insignificant in drilling CFRP laminates. The optimal drilling performance for the thrust force was obtained at 0.01 mm/rev feed rate, 800 rpm speed spindle and 6 mm drill diameter settings. The best combination to attain smaller delamination factor was 0.01 mm/rev feed rate, 800 rpm speed spindle and 10 mm drill diameter.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
