Synthesis, X-ray diffraction and dielectric studies of the ceramic samples (1−x)BaTiO3⋅xPbFe2/3W1/3O3 (0≤x≤1) system

Abstract

Ceramic samples of the ([Formula: see text])BaTiO3⋅xPbFe[Formula: see text]W[Formula: see text]O3, [Formula: see text] (([Formula: see text])BT⋅xPFW) system were synthesized by solid-state reactions method. The samples were characterized by X-ray diffraction (XRD) and dielectric studies, as well as by the measurements of the thermally stimulated depolarization currents (TSDC). It was found that the predominant phase in the samples is presented by the (Ba[Formula: see text]Pbx)(Ti[Formula: see text]Fe[Formula: see text]W[Formula: see text])O3 solid solutions with a perovskite structure, herewith the samples with [Formula: see text] are practically single-phase, and with [Formula: see text] contain the impurity phase BaWO4 (up to 15 mass.% at [Formula: see text]–0.90). Information has been obtained about the changes in the structural and dielectric characteristics of the solid solutions with the change of their composition. It is established that the solid solutions crystal lattice symmetry at 296 K changes from tetragonal at [Formula: see text] to cubic at [Formula: see text]. An increase in the PFW content in solid solutions causes a gradual change in their properties from ferroelectric at [Formula: see text] to relaxor ferroelectric at [Formula: see text], and then to properties similar to those of the dipole glass with weak or zero correlation between dipoles at [Formula: see text]. The addition of BT to PFW leads to rather quick degradation of the relaxor ferroelectric properties of PFW in the region [Formula: see text]–1.0.