Abstract
The fluorene-based poly(dioctylfluorene-alt-biphenylamine)s with styrylpyridyl group were synthesized by using Pd-catalyzed polycondensation reaction. These hole injection/transport polymers showed very good solvent resistance after photo-crosslinking which could facilitate the subsequent spin coating of the emitting layer polymer solution. Moreover these polymers could be patterned by using distyrylpyridyl alkyl monomer (DSM) as crosslinking agents. The OLED devices with configuration of ITO/HIL/Alq3:NPD/LiF/Al in which synthesized polymer was used as hole injection layer (HIL) were fabricated and their performance was compared with the commercially available PEDOT:PSS as HIL layer.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.