Synthesis of metal-intermetallic laminate (MIL) composites with modified Al3Ti structure and in situ synchrotron X-ray diffraction analysis of sintering process

Abstract

Al3Ti-based alloys attract exceptional attention due to their high specific mechanical properties. However, their application is still insufficient due to their low ductility and fracture toughness. Several approaches were previously proposed to address these problems. The first one is stabilization of the cubic modification of titanium trialuminide by alloying. Another approach consists in fabricating metal-intermetallic laminated composites (MIL). In this study, we combined both methods to synthesize the first MIL composite with cubic Al3Ti interlayers. Copper additions were used to stabilize the cubic modification of Al3Ti and produce a novel Ti-Al5CuTi2 MIL composite. First mechanical characterization by indentation tests showed that the binary Al3Ti intermetallic tended to crack at a load of 0.2 kg while the fracture was not observed in the Al5CuTi2 layers at least at a load of 1 kg. These results are an indirect evidence of a higher ductility and fracture toughness of the composite with cubic Al3Ti compared to tetragonal one. The sequence of the phase transformations in the Al-Ti-Cu system was studied using in situ synchrotron X-ray radiation diffraction. The formation of Al5CuTi2 occurred via several intermediate stages including eutectic melting of Al and Cu and the formation of binary AlCu and Al3Ti compounds.